| |
Repsol Hidroulico C-3 EP 32
Description
Repsol Hidr¨¢ulico C-3 oils are highly refined, paraffin base, hydraulic transmission fluids with special additives enabling them to meet the requirements of GM Allison fluids of the C-3 type. They are endowed with exceptional rust, oxidation and foam resistance properties as well as anti-wear qualities.
Recommended uses
Recommended for use in hydraulic transmission circuits of lorries, buses and Public Works and Mining machinery which are subject to use in severe conditions requiring a fluid of this type which meets the afore-mentioned Allison C-3 type specifications.
Qualities
Anti-oxidation properties.
Good stability against foam formation.
High anti-corrosion and sludge formation resistance.
High viscosity index.
Low freezing point.
Does not alter rubber components.
Excellent viscosity at low temperatures.
Quality Level
GM Allison tipo C-3
Technical Characteristics
Available in
Bulk and 185-kilo drums.
Hazard Identification
This product is not classified as toxic or hazardous under current legislation.
Handling
Certain minimum precautions to avoid prolonged contact with the skin should be taken when handling. The use of gloves, visors or masks is recommended in order to avoid splashes.
Health and safety hazards
Inhalation: Minimum risk of inhalation as it is a non-volatile product.
Ingestion: Do not provoke vomiting. Drink water. Seek medical assistance.
Contact with Skin: Wash with abundant water and soap.
Eyes: Wash with abundant water.
General measures: Seek medical assistance.
Fire fighting measure
No special measures are required.
Fire control: Foams, dry chemicals, CO2, water spray. Do not apply water jet directly as this may cause the product to spread.
Environmental precautions
Danger of physical contamination in the case of spillage (water flows, coastal areas, the ground, etc.) due to its floating capacity and oily consistency which may cause damage to fauna and flora with which it comes into contact. Avoid its penetration into water containers or outlets.
Decontamination and cleaning: Treat as an accidental oil spillage. Avoid spreading by using mechanical barriers and eliminate using both physical and chemical means.
Unless otherwise specified, the values cited in technical characteristics should be considered as typical. |
|
